Each bolt is backed up by metallic and rubber washers to avoid leaks and wobbling.Ī toilet tank to bowl gasket is also installed on the outside of the flush valve to prevent the toilet from leaking between the tank and the bowl. Toilet tank are are mounted on top of the toilet bowl using 2 and sometimes 3 bolts.
#How to install toilet bolts to floor how to
If that is your situation, I will show you how to remove and install a toilet tank. There you have it.If you have a two-piece toilet, chances are that you might at some point want to replace the toilet tank and not the bowl. Reconnect the waterline and turn the water supply back on. Place the nuts onto the bolts and tighten them just enough with a wrench. Press it down and do not rock it, as this movement can destroy the seal created by the wax ring.
Set the unit straight down over the bolts and then lower it to the floor. Lift the toilet and make sure the holes in its base are aligned with the bolts in the flange. Re-Install The Toilet.īefore placing back the toilet, see to it that the new wax ring is placed at the center of the flange with the ring’s rounded edge facing up. Now, you can finally slide the spacer down over the bolts, making sure that it lies flat on top of the gasket. Also, take note that the bolts should be evenly aligned directly across from each other. Slide the new toilet bolts into the same holes from where you removed them, noting of the notch and groove on the flange’s both sides, which allow the wide end of the bolts to fit into the flange. Place the gasket onto the center of the flange and then place the spacer onto the gasket.
#How to install toilet bolts to floor free
Wipe the existing toilet flange up with a rag and mineral spirits to make sure it is clean and free of wax before you install the spacer. Remember that you cannot reuse the ring once you remove the toilet. Remove the wax ring from the center of the flange and clean it off of any remaining wax using a putty knife. When lifting your toilet, make sure you do it straight up, and then set it on old towels in a secure area in your bathroom or another corner in your house. Take note that when installing the spacer, you will need to use longer bolts.
Then, slide the 2 closet bolts out of the existing flange. Place the tip of the screwdriver at the cap’s base and then pry it upwards. Start by removing the nuts on the toilet bolts with a set of wrenches to loosen the water line connections and removing the bolt caps with a flat screwdriver. Disconnect The Water Line From The Shutoff Valve. You can use an old towel or a wet vacuum to take out remaining water in the bowl and in the tank. Then, flush the toilet to drain out water as much as possible. Make sure you cut the water supply by turning off the shutoff valve that is usually found on the wall behind your toilet. Here is how to install a toilet flange spacer: 1. And to prevent leaks, this component must be at the same level as the floor or your toilet will not be sealed properly. A toilet flange has a plastic or metal ring to which the bowl is secured to. If you have just installed new flooring in your bathroom, but immediately noticed some leaks from the toilet base, you need to use a toilet flange spacer.
0 kommentar(er)
